| |
|
|
 |
|
|
|
|
| |
 BaalFTTx
- Series |
|
|
|
| |
|
|
| |
|
|
| |
Specifications
|
|
| CATV Receiver
Module |
| Fiber type |
Single
mode 9/125 µm |
| Optical connector |
SC/APC |
| Optical input
wavelength |
1280
...1610 nm |
| Optical input power |
Min.
–10 dBm, max. -3 dBm |
| RF connector |
F female |
| RF impedance |
75
Ω |
| RF bandwidth |
47
… 1000 MHz |
| Receiver noise
current |
Typ. 4,5
pA/√Hz |
| RF output level |
≥ 88 dBµV @ - 5 dBm optical input power
|
| Management and Diagnostics |
Remote ON/OFF switching, optical input level monitoring
|
| |
|
| Ethernet Transceiver Module |
| Fiber type |
Single
mode 9/125 µm |
| Optical WAN connector |
SC/PC* |
| Ethernet
wavelength |
TX: 1260
...1360 nm, typical 1310 nm
RX: 1480 ...1600 nm, typical 1550 nm |
| Standard compliance |
IEEE802.3u 100BASE-BX10 |
| |
| LAN Twisted Pair Interface |
| Standard compliance |
Fully compliant with IEEE802.3 10Base-T,
IEEE802.3u 100 Base-TX standards and IEEE802.3x |
| Mode |
integrated four-port switch
auto-cross-over, half/full-duplex, 10/100Mbps |
| Connecotor |
4 x RJ-45 |
| |
| Layer 2 Software Features |
| Layer 2 Protocols |
RFC 2236-IGMP Snooping v1, v2
802.3x Flow-Control, Pause-Frame and Backpressure, auto-negotiation |
| |
| Switch Device Features |
| Device Mode |
Store and Forward |
| VLAN |
IEEE 802.3Q - VLAN: Up to 16 groups
Port-Based VLAN (Port-Grouping) |
| Quality of Service / Class of Service |
IEEE 802.1p - Class of Service Layer 2, RFC 2474 / 2475 – Diffserv, 4 queues of priority, Port based priority, VLAN based priority |
| Security |
Broadcast Storm Protection |
| Rate Limiting |
Ingress- / Egress-Rate limiting (granularity 200kbps) |
| MAC-address table size |
2k |
| |
| Voice Features |
| SIP Support |
SIP 2.0 - RFC 3261 - Session Initiation Protocol Version 2.0
|
| Voice Codecs |
G.711 - a-Law/µ-Law (64kBps), G.726 – 16, 24, 32 and 40 kbps,
optional G.729a – 8 kbps and G.723.1 – 5.3 / 6.3kbps |
| Features |
Two separated SIP-accounts, Caller-ID (CLIP) via FSK and DTMF, Echo cancellation (ITU G.168), DTMF-Support (via Inband, RFC2833 or SIP-message), adjustable volumes of microphone and speaker, adjustable phone-line-impedance, Call-Waiting, Call-Transfer , 3-way calling, STUN-Support and
T.38 fax-support |
| |
| Management |
BKtel Provisioning System |
| Protocols |
ARP, IP, ICMP, UDP, TCP, DHCP, DNS, SYSLOG, TFTP, NTP, SNMP, HTTP, Telnet |
| DHCP Options (Selection) |
DHCP Option 66 - TFTP-Server
DHCP Option 67- Boot File Name (remote-configuration-file) |
| SNMP |
SNMP v1, v2c
supported MIBs: RFC1213, DOCSIS Cable Device MIB, BKtel Enterprise MIB |
| |
| Status LEDs |
Power, Device status, Phone, WAN and LAN link/activity, CATV status |
| |
| General Technical Data |
| Size (height, depth, width) |
176 mm x 44 mm x 288 mm |
| Weight |
710g |
| Power Supply Voltage |
12 VDC |
| Climatic spefication: |
|
| Operation |
ETS 300 019, class 3.1 Temperature: 0°C - 40°C (45°C) |
| Storage |
ETS 300 019, class 1.2 |
| |
| * One-fiber version available with integrated WDM filter (1310 nm/1490 nm Optical Ethernet & 1550 nm CATV/SAT video overlay): SC/APC connector. |
|
|
|
BKtel communications GmbH
- www.bktel.com - E-Mail: sales@bktel.com
Specifications subject to change
without notice |
|
|
|
| |
|
|
|
XON600.SVC optical network unit delivers high-speed internet and full-spectrum CATV in FTTH (Fiber-to-the-Home) access networks. It combines a 100Base-FX to 10/100Base-TX managed switch, Voice over IP (VoIP) based telephony and a broadband optical television (CATV) receiver, allowing up to 15 km single-mode fiber connectivity. 